![]() ![]() It will carry on like this for ever until you remove the key from the ignition or the battery runs flat. Once at the end of the logged fault code list, it will go to the beginning again, giving you plenty of time to note down the code (on each fault code shown, there will be a pause before it shows the next one). Each fault code is repeated 3 times and then it moves onto the next one (if any). ![]() Once the wire link is in place and the engine is running, the ECU warning lamp will begin to flash out the codes (wait for the initial boot up check that lights up all the warning lamps). The engine ideally needs to be running when reading the fault codes, otherwise it may show incorrect fault codes. The following chapters are taken from the How To on The Simtec 56.5 fuel systems use a 4 digit flash code. ![]() The diagnostics procedure of the Simtec 56.5 is the same as for the newer 70.x management. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |